This Wiki page is edited by participants of the WCAG Working Group. It does not necessarily represent consensus and it may have incorrect information or information that is not supported by other Working Group participants, WAI, or W3C. It may also have some very useful information.

Relative luminance

Revision as of 05:28, 24 October 2012 by Lguarino (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

WCAG definition of relative luminance

the relative brightness of any point in a colorspace, normalized to 0 for darkest black and 1 for lightest white

Note 1: For the sRGB colorspace, the relative luminance of a color is defined as L = 0.2126 * R + 0.7152 * G + 0.0722 * B where R, G and B are defined as:

  • if RsRGB <= 0.03928 then R = RsRGB/12.92 else R = ((RsRGB+0.055)/1.055) ^ 2.4
  • if GsRGB <= 0.03928 then G = GsRGB/12.92 else G = ((GsRGB+0.055)/1.055) ^ 2.4
  • if BsRGB <= 0.03928 then B = BsRGB/12.92 else B = ((BsRGB+0.055)/1.055) ^ 2.4

and RsRGB, GsRGB, and BsRGB are defined as:

  • RsRGB = R8bit/255
  • GsRGB = G8bit/255
  • BsRGB = B8bit/255

The "^" character is the exponentiation operator. (Formula taken from [sRGB] and [IEC-4WD]).

Note 2: Almost all systems used today to view Web content assume sRGB encoding. Unless it is known that another color space will be used to process and display the content, authors should evaluate using sRGB colorspace. If using other color spaces, see Understanding Success Criterion 1.4.3.

Note 3: If dithering occurs after delivery, then the source color value is used. For colors that are dithered at the source, the average values of the colors that are dithered should be used (average R, average G, and average B).

Note 4: Tools are available that automatically do the calculations when testing contrast and flash.

Note 5: A MathML version of the relative luminance definition is available.

Additional guidance when applying to Electronic Documents and Software Aspects of Products

This applies directly as written, and as described in WCAG 2.0 glossary replacing "Web Content" with "Content".

NOTE: Because relative luminance is defined such that it cannot directly apply to hardware we draw the readers' attention to the note in the introduction which reads:

"This document does not comment on hardware aspects of products, non-UI aspects of platforms, or the application of WCAG 2.0 for user-interface components as a category, because the basic constructs on which the WCAG 2.0 and/or its conformance are built do not apply to these."